Hi
I have to upgrade and convert an old machine that was used to cut with
gas. It uses some Panasonic MCDHT3520 servo drives.
These drives has a pulsed input for position and an analog +- 10v input
for velocity mode.
The question is what mode is better to use with LCNC and Mesa cards,
velocity or position?
I will use one of the Ethernet solutions from Mesa with a panel PC.
-----------------------------
Regards / Groete
Marius D. Liebenberg
+27 82 698 3251
+27 12 743 6064
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
