On 07/26/2017 05:36 PM, Charles Brauer wrote:
I can't get the hal file right to run a stepper tripod. If someone could share one that runs on wheezy I would be most appreciative. I was thinking I could build a 3d printer with this.
I ran sim/tklinuxcnc/tripod.ini on 2.7 and master, and both worked, as far as I can tell.
-- Sebastian Kuzminsky ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
