On Saturday 22 July 2017 22:01:15 Nicklas Karlsson wrote: > Could you send your configuration files? > Might not be needed Nicklas. For lack of anything else to do, I just got thru nuking what was in the pi's halfile, and replaced it with the same stanza from TLM's hal file, and it at least will let it run.
And the little toolchanger box now shows up and goes away. I had not been seeing that till today I fed the missus, and she's out like a light, so I'll see if I can get to the garage and check it against my gcode for function. W/o making enough noise to wake her. Yup, made it thru the first 2 tool changes cutting air. The backplot trace as it runs is considerably to the left of the initial scan's backplot though. So I'll go restart it, this time with a tool. ;-) This code works: unlinkp iocontrol.0.tool-change unlinkp iocontrol.0.tool-changed loadusr -W hal_manualtoolchange net tool-change-request iocontrol.0.tool-change => hal_manualtoolchange.change net tool-change-confirmed iocontrol.0.tool-changed <= hal_manualtoolchange.changed net tool-number iocontrol.0.tool-prep-number => hal_manualtoolchange.number net tool-prepare-loopback iocontrol.0.tool-prepare => iocontrol.0.tool-prepared > > Noisy, wet Saturday evening in progress. 2.75" of noisy, wet, finally stopped. Flash flood warnings out for low country. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
