On 02/16/2017 09:01 AM, Marius Alksnys wrote: > > > 02/16/2017 05:25 PM, Sebastian Kuzminsky rašė: > ... >> There were a couple of terrible "surprise move" bugs in 2.7.5 and 2.7.6. >> As far as we know these are all fixed in 2.7.7 and later. >> >> Which version of LinuxCNC were you running when you had this surprise >> motion? I really hope it was something older than 2.7.7! > > It was 2.7.8 and now 2.8.0-pre1-2846-g9e23976, and I can't find a way to > offer an operator to stop the program in the middle. It just moves after > stop. Every time.
That sounds frustrating, but it's great that it's super repeatable, that'll make it easier to find and debug. I tried to reproduce the problem here this morning in 2.7, but could not get anything bad to happen. Can you reproduce it in a sim config, and send a detailed recipe telling me how you reproduce it on your system? If it's not reproducible in sim, the second best option is to post a complete copy of your config (along with the steps you take to reproduce the problem) and i'll try to whittle it down to something that i can reproduce locally. -- Sebastian Kuzminsky ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
