On 02/02/2017 03:27 AM, andy pugh wrote: > I am using a typical eBay HuangYang VFD on the lathe, and it works > nicely with the HAL module (even though it isn't _actually_ real > modbus, or so I have heard) > Some eBay adverts make a point of stressing that they are selling > genuine HuangYang, not fake HuangYang.
I've used Huanyang VFDs on machines at the local hackspace. If you go this route, two notes of caution: 1. Make sure to use an AC reactor on the input. 2. The LinuxCNC Huanyang driver only works with the older style of Huanyang VFDs. It does not work with the newer GT-series models. I'm working on a new driver for Huanyang GT VFDs, but it's not ready yet. -- Sebastian Kuzminsky ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
