On 12/16/2016 07:29 AM, Gene Heskett wrote: > Greetings all; > > During the brief time this was working, one of the things I found was a > need for a backlash setting in the 8 or 9 thou range for Z. > > Putting a dial on the end of the screw, the measured end play there was > around .0055". > > So theres 2 places that need adjusting. The nut that draws the bearing > inners together is quite tight. So I am assuming I'll have to take a > few thou off the faces of the inner races. Or, you could make a washer out of .005" or .006" shim stock and be able to adjust it with gentle sanding.
Jon ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
