On Thu, 8 Dec 2016, Steve from Tube Gauge wrote: > Date: Thu, 08 Dec 2016 12:45:45 -0500 > From: "[utf-8] Steve from Tube Gauge" <[email protected]> > Reply-To: "Enhanced Machine Controller (EMC)" > <[email protected]> > To: [email protected] > Subject: [Emc-users] Red Cap Fanuc amp part number > > I found a part number on the printed circuit board that has all 3 axis on it. > Under the PCB are the amps for each motor. Is this the correct number to > identify if the amps are "easily retrofitted" to EMC2: A16B-1000-0280/06A ?
Steve V I think so (I think thats a Anlaog servo drive PCB part number) but the A06B-xxxx number is really whats required This is typically on the frame, not on the PCB ------------------------------------------------------------------------------ Developer Access Program for Intel Xeon Phi Processors Access to Intel Xeon Phi processor-based developer platforms. With one year of Intel Parallel Studio XE. Training and support from Colfax. Order your platform today.http://sdm.link/xeonphi _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users Peter Wallace Mesa Electronics (\__/) (='.'=) This is Bunny. Copy and paste bunny into your (")_(") signature to help him gain world domination. ------------------------------------------------------------------------------ Developer Access Program for Intel Xeon Phi Processors Access to Intel Xeon Phi processor-based developer platforms. With one year of Intel Parallel Studio XE. Training and support from Colfax. Order your platform today.http://sdm.link/xeonphi _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
