Andy, I misread the guide. I installed the package with the live CD in section 3.4 and then went on to section 3.7.1, thinking I was supposed to do that in addition, when I should have been done. I will just start over. Thank you for your time.
Bart On Mon, Dec 5, 2016 at 11:31 AM, Bart Winkler <[email protected]> wrote: > Andy, > > Thank you for looking at this. The link is http://linuxcnc.org/docs/2.7/ > pdf/LinuxCNC_Getting_Started.pdf. > John T. has the same thing on his website. > > Thanks, > Bart > > On Mon, Dec 5, 2016 at 5:09 AM, andy pugh <[email protected]> wrote: > >> On 5 December 2016 at 00:33, Bart Winkler <[email protected]> wrote: >> > I am attempting to follow the installation instructions in the quick >> start >> > guide. >> > >> > I was supposed to mark linux-image-3.2-4-686-pae and linux-image-686-pae >> > for >> > complete removal in synaptic package manager. >> >> Can you give us a link to the quick-start guide that you are following? >> >> -- >> atp >> "A motorcycle is a bicycle with a pandemonium attachment and is >> designed for the especial use of mechanical geniuses, daredevils and >> lunatics." >> — George Fitch, Atlanta Constitution Newspaper, 1916 >> >> ------------------------------------------------------------ >> ------------------ >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
