last time I had do to something similar, I splitted the last move and inserted my M code between the two moves.
Worked well. Le 08/06/2015 08:59, a k a écrit : > Hi > i think that instead of look ahead for G0 it will be better to have/create > new M code (M100 or M(n)) that will: > after running on G1 mode and after reading code G0 will move Z up 1" (or > some parameter a=..., then move back on the same last trajectory about 0.5" > -0.75" or some parameter b=.., then down to initial Z or parameter C=..., > and reread last 0.5" =0.75" trajectory motion. > this new M code will open new and necessary capability of linux cnc -- for > use with welding application. > How difficult it will be to create such M code? > Any idea direction how to do that? > > thank you > aram > > > > On Sun, Jun 7, 2015 at 3:16 PM, a k <[email protected]> wrote: > >> hi >> i am interesting if it will be possible to Linux cnc look ahead 4-5 lines >> before G0 and then send some signal out? >> right now i have a working system where when system reads G0 signal going >> out. >> now i want to this signal went out like 0.5" - 0.75" of travel before >> actually system reads G0 >> when i said 0.5" - 0.75"---before G0 machine moves on G1 and when >> this travel will be around 0.5" - 0.75" before the end of travel i want to >> signal that indicates G0 go out. >> >> thank you >> aram >> > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
