On 15 June 2015 at 15:44, Pete Matos <[email protected]> wrote: > REALLY want to make it work as it came from the > factory.
Why not start by making M19 work? You can then integrate that into toolchange later. http://wiki.linuxcnc.org/cgi-bin/wiki.pl?SpindleOrient Which version of linuxCNC are you using? I recently pushed an enhancement to the "orient" HAL component that has an output to twiddle the motion.spindle.is-oriented pin. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
