That 'spindle' looks a bit... spindly. A DC motor with a thin shaft, that has an ER collet holder attached with a grub screw. Good enough for plastic and wax I suppose. You could make up a nose shroud for it with extra bearings.
Regards Roland On 2 June 2015 at 20:53, <[email protected]> wrote: > On Tue, 2 Jun 2015, Ralph Stirling wrote: > > > Best is to use an enable signal on the controller when it > > has one. Next best is to turn the controller on and off. > > Worst is putting anything between the controller and the > > motor. On some motors and controllers disconnecting > > the motor from the controller under load can damage > > the controller. > > will do, thanks > > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
