-----Original Message----- From: Mark Johnsen Sent: Monday, January 12, 2015 12:00 AM To: [email protected] Subject: [Emc-users] Anilam Crusader M Servo Control Voltage
>I have most of the electrical worked out for my Anilam Crusader M retro to >a mesa 5i25/7i77. I haven't torn apart anything, but close. > <snip> > >Also, the best way I can see to check this is look up what the max rpm is >for the motor and see if I can reach that at 10vdc. If I'm 2/3 off, apply >15vdc and see if I hit the spec? > >Suggestions? > >Thanks, >Mark I converted my Crusader M Lathe using mesa 5i25 and 7i77 (IIRC). The amps worked fine with the +/- 10V signal. I think the +/-15V is just the power for the op-amps. I would guess if works with higher control voltages by adjusting a gain pot for full output at different voltage inputs. I just figured it used +/-10VDC like my Crusader II mill does, and it worked out great. Roger Neal ------------------------------------------------------------------------------ New Year. New Location. New Benefits. New Data Center in Ashburn, VA. GigeNET is offering a free month of service with a new server in Ashburn. Choose from 2 high performing configs, both with 100TB of bandwidth. Higher redundancy.Lower latency.Increased capacity.Completely compliant. vanity: www.gigenet.com _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
