Movement at last! Now I can get on with axis tuning, then getting the coolant pump going, etc.
Thanks Pete C. ------Original Mail------ From: "andy pugh" <[email protected]> To: "Enhanced Machine Controller (EMC)" <[email protected]> Sent: Wed, 29 Oct 2014 20:53:39 +0000 Subject: Re: [Emc-users] Lathe conversion with Mesa 5i25 / 7i76 On 29 October 2014 20:48, <[email protected]> wrote: > Ok, I added a separate field 5V supply with common ground with the field 24V > supply. I also fixed a bad connection on the MPG A channel and the count > value does indeed go up and down with the MPG wheel. What I still don't have > is any axis movement (keyboard jog works fine). :( For jogging to happen: 1) the encoder counts value needs to be connected to the axis.N.jog-counts 2) the axis.N.jog-enable pin needs to be TRUE (either setp or net) 3 the axis.N.jog-scale value needs to be non-zero (either net or setp) -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
