On Fri, 7 Feb 2014, [email protected] wrote: > Date: Fri, 7 Feb 2014 09:51:44 -0600 > From: [email protected] > Reply-To: "Enhanced Machine Controller (EMC)" > <[email protected]> > To: EMC <[email protected]> > Subject: [Emc-users] Adding a 4th axis > > Hi, I am adding a 4thaxis to my VMC. I am using a 5i20 &(2)7i77&(1)7i33. My > plan is to use a gecko servo drive to save inputs. I only have a few outputs > left on the one 77. (the 33 is full) Will the 7i77 give good step and > direction results or should I switch to 7i42 to be rid of the isolators? > > Terry
Assuming thats a 7I37, I would use a 7I42Ta instead to drive stepmotors because the 7I37 is really too slow for this application > ------------------------------------------------------------------------------ > Managing the Performance of Cloud-Based Applications > Take advantage of what the Cloud has to offer - Avoid Common Pitfalls. > Read the Whitepaper. > http://pubads.g.doubleclick.net/gampad/clk?id=121051231&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > Peter Wallace Mesa Electronics (\__/) (='.'=) This is Bunny. Copy and paste bunny into your (")_(") signature to help him gain world domination. ------------------------------------------------------------------------------ Managing the Performance of Cloud-Based Applications Take advantage of what the Cloud has to offer - Avoid Common Pitfalls. Read the Whitepaper. http://pubads.g.doubleclick.net/gampad/clk?id=121051231&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
