2014-01-28 Peter C. Wallace <[email protected]> > > > A couple problems: > > 1. You need newer source (V3 muxed encoder) I would fetch source from Mesa >
So should I just change the version to 03 in vhd file? Or is there something else I need to do? > 2. There's no support for mixing encoder types (muxed and non muxed) in the > current hostmot2 driver. Ive worked around this by using only muxed > encoders > for example in your config you could set the number of muxed encoders to 14 > replace the encoders on IO 54 through 65 with muxed encoders (numbered > 3..6) > > the main side effect of this is wasted space and odd numbering of the > higher > ordered encoders (6,8,10,12) > Ok, understood about mixing encoder types. Perhaps I did not emphasise it clearly enough - I do not have second 7i48 card, I want to feed encoder pulses directly to 5i23 card - I need it for tool height control. Will it work with muxed encoder? I somehow doubt that, but I will be happy to be proven wrong. Viesturs ------------------------------------------------------------------------------ WatchGuard Dimension instantly turns raw network data into actionable security intelligence. It gives you real-time visual feedback on key security issues and trends. Skip the complicated setup - simply import a virtual appliance and go from zero to informed in seconds. http://pubads.g.doubleclick.net/gampad/clk?id=123612991&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
