On 25 October 2013 16:39, Leonardo Marsaglia <[email protected]> wrote:
> I know Andy worked with the 6i25 and it works well using the 5i25 firmware, > but I don't know if anybody has tried this board with the 7i77 and LinuxCNC. I haven't, but I wouldn't expect any problems. > I'm planning to use it for drive 1 servo with encoder, I know it's a lot > for these purpose since the board can handle 6 servos It does seem like rather more hardware than strictly necessary. I assume you are constrained by EU stock? -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ October Webinars: Code for Performance Free Intel webinars can help you accelerate application performance. Explore tips for MPI, OpenMP, advanced profiling, and more. Get the most from the latest Intel processors and coprocessors. See abstracts and register > http://pubads.g.doubleclick.net/gampad/clk?id=60135991&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
