john what tool did you use to drill the center hole? was it interpolated with an endmill? and i am presuming from the code x and y 0 is center of the part?
PRIVACY NOTICE: Warning - any person and/or institution and/or Agent and/or Agency of any governmental structure including but not limited to the United States Federal Government also using or monitoring/using this website or any of its associated websites, you do NOT have my permission to utilize any of my profile information nor any of the content contained herein including, but not limited to my photos, and/or the comments made about my photos or any other "picture" art posted on my profile. You are hereby notified that you are strictly prohibited from disclosing, copying, distributing, disseminating, or taking any other action against me with regard to this profile and the contents herein. The foregoing prohibitions also apply to your employee , agent , student or any personnel under your direction or control. The contents of this profile are private and legally privileged and confidential information, and the violation of my personal privacy is punishable by law. UCC 1-103 1-308 ALL RIGHTS RESERVED WITHOUT PREJUDICES jeremy youngs On Sun, Jun 16, 2013 at 7:57 PM, John Alexander Stewart <[email protected]>wrote: > Martin: > > On Sun, Jun 16, 2013 at 7:02 PM, Martin Dobbins <[email protected]> wrote: > > > C'mon John too many variables here unless you show us the G code, after > > all that's what Linuxcnc runs on... > > > > Another (especially experienced) set of eyes more than welcome. > > I think this will work for the GCode: > > https://www.dropbox.com/s/euvmvc4qpj0dhrj/starTest4-31mmDia.nc > > You interested in the cambam file and the DXF file? > > > John. > > ------------------------------------------------------------------------------ > This SF.net email is sponsored by Windows: > > Build for Windows Store. > > http://p.sf.net/sfu/windows-dev2dev > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ This SF.net email is sponsored by Windows: Build for Windows Store. http://p.sf.net/sfu/windows-dev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
