Thanks Chris! Good grief, I feel a little silly... - Claude
On Wed, Jan 30, 2013 at 8:42 PM, Chris Radek <[email protected]> wrote: > On Wed, Jan 30, 2013 at 08:32:49PM -0800, Claude Zervas wrote: > > Hello, > > > > I hope this isn't too dumb of a question. I did search the archives and > the > > manual first but couldn't find an answer there. > > The problem is that the MAX_VELOCITY set for my Z axis is ignored by > > linuxcnc during both homing and feeds. I have it set to 0.2 IPS but Axis > > shows 12 IPS during homing. Is there something I'm missing? > > The velocity readout in AXIS is inches/minute, like gcode. So this > behavior is correct. > > > > > ------------------------------------------------------------------------------ > Everyone hates slow websites. So do we. > Make your web apps faster with AppDynamics > Download AppDynamics Lite for free today: > http://p.sf.net/sfu/appdyn_d2d_jan > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Everyone hates slow websites. So do we. Make your web apps faster with AppDynamics Download AppDynamics Lite for free today: http://p.sf.net/sfu/appdyn_d2d_jan _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
