On Fri, 6 Jul 2012, Eric Keller wrote: > Date: Fri, 6 Jul 2012 13:29:19 -0400 > From: Eric Keller <[email protected]> > Reply-To: "Enhanced Machine Controller (EMC)" > <[email protected]> > To: "Enhanced Machine Controller (EMC)" <[email protected]> > Subject: [Emc-users] Mesa 6i26 work with EMC? > > I suspect it will, but I haven't seen anyone mention it. I propose to use > it with a servo system, so I would think any latency coming from PCIe would > have minimal effect, is that right? > Eric
It should work now masquerading as a 5I25 (if loaded with 5I25 firmware) The latency just makes it a little slower. It is fine for servo and stepper systems. I would only have reservations if used for systems with a huge amount of I/O or >4 KHz servo thread rates > ------------------------------------------------------------------------------ > Live Security Virtual Conference > Exclusive live event will cover all the ways today's security and > threat landscape has changed and how IT managers can respond. Discussions > will include endpoint security, mobile security and the latest in malware > threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > Peter Wallace Mesa Electronics (\__/) (='.'=) This is Bunny. Copy and paste bunny into your (")_(") signature to help him gain world domination. ------------------------------------------------------------------------------ Live Security Virtual Conference Exclusive live event will cover all the ways today's security and threat landscape has changed and how IT managers can respond. Discussions will include endpoint security, mobile security and the latest in malware threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
