On Tue, 13 Dec 2011, Tom Easterday wrote:
> Date: Tue, 13 Dec 2011 11:45:41 -0500
> From: Tom Easterday <[email protected]>
> Reply-To: "Enhanced Machine Controller (EMC)"
> <[email protected]>
> To: "Enhanced Machine Controller (EMC)" <[email protected]>
> Subject: Re: [Emc-users] Encoders
>
> Thanks for the info Jon. We are seeing a small (about 0.001) position error
> just on initial acceleration and deceleration that we cannot account for.
> It may be due to the encoder. Since this is mainly a plasma machine we will
> probably live with it. If we need to do better we'll look at replacing the
> encoders. We now know the string attached to our cheap encoder :-) -Tom
>
Have you tried using FF2 to tune out the lag/lead during accel/decel?
(a jerk limited profile would also help)
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
------------------------------------------------------------------------------
Systems Optimization Self Assessment
Improve efficiency and utilization of IT resources. Drive out cost and
improve service delivery. Take 5 minutes to use this Systems Optimization
Self Assessment. http://www.accelacomm.com/jaw/sdnl/114/51450054/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
