for master, I've expanded the parameters section quite a bit, and I did it in 'G-Code Overview' for numbered and named parameters
http://www.linuxcnc.org/docs/devel/html/gcode/overview.html#_a_id_sec_parameters_a_parameters_variables_in_g_code_programs note the named parameter stuff is applicable to master, not earlier branches -m, Am 12.12.2011 um 18:43 schrieb andy pugh: > On 12 December 2011 17:34, Ralph Stirling <[email protected]> > wrote: >> I've been studying the documentation and the source code for information on >> G-code readable/writeable parameters. I have yet to find a good summary of >> all the defined parameters in a single place. So far, I've found #5161-#5390 >> and #5400-#5428 defined in interp_array.cc. #5061-5070 are defined in >> interp_internal.cc, and rs274ngc_pre.cc defines #5599 to #5601 and #5399 to >> #5413. Some of these are mentioned in the G Code Reference manual. >> Have I missed any? > > I think most of them are here: > http://www.linuxcnc.org/docview/2.5/html/common/machining_center.html#_parameters_a_id_sub_parameters_a > > Though I agree that isn't the most obvious place to look. > > -- > atp > The idea that there is no such thing as objective truth is, quite simply, > wrong. > > ------------------------------------------------------------------------------ > Learn Windows Azure Live! Tuesday, Dec 13, 2011 > Microsoft is holding a special Learn Windows Azure training event for > developers. It will provide a great way to learn Windows Azure and what it > provides. You can attend the event by watching it streamed LIVE online. > Learn more at http://p.sf.net/sfu/ms-windowsazure > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Systems Optimization Self Assessment Improve efficiency and utilization of IT resources. Drive out cost and improve service delivery. Take 5 minutes to use this Systems Optimization Self Assessment. http://www.accelacomm.com/jaw/sdnl/114/51450054/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
