On Wed, 2 Nov 2011, andy pugh wrote: > On 2 November 2011 09:03, <[email protected]> wrote: > >> That is my other option but I have realign my work >> For this project I start with 1/4" bit to remove a lot of material >> Then switch to a 1/8" bit then to a 1/16" bit to finish >> If I change routers I have to hope I get the alignment correct > > > Do you have access to a lathe? It should be possible to modify one of > the existing extensions, though I think I would be more tempted to > modify one of these: > http://www.ebay.co.uk/itm/ER11-10MM-STRAIGHT-SHANK-L100MM-CHUCK-CNC-MILLING-LATHE-TOOL-WORKHOLDING-L29-/150688723489
I do not have access to a lathe I may have to make friends with a local machinist Could get pricey Another thought I had was to scrounge for an old dremel and cut off the shaft ------------------------------------------------------------------------------ RSA® Conference 2012 Save $700 by Nov 18 Register now! http://p.sf.net/sfu/rsa-sfdev2dev1 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
