Hey Folks:
I feel silly asking this question, but here goes. I ran into an issue using
peck drilling with the tool retract. The end result was my Z stepper was
missing pulses on the retract. So I've derated the max accel and vel on the Z
axis and everything looks good, however what I'd really like to do is run my
program with the X and Y disabled. The idea being I want to monitor Z with a
dial indicator and make sure the start and end conditions are correct. I can't
find an axis disable command in g code or in the EMC2 command set. Is there
something I'm missing? I'm sure there has to be a way to do this, and I'm sure
it staring me in the face. Can someone show me how stupid I am and point this
out to me?
Thanks
Andrew
------------------------------------------------------------------------------
This SF.net email is sponsored by Sprint
What will you do first with EVO, the first 4G phone?
Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
