On Fri, 2010-07-23 at 07:27 -0500, James Louis wrote: > Thanks for the reply Kirk. Having explained it, would you (or anyone) mind > translating the following generic sample to "net" without deleting any signal > names? : > > newsig signalnameA bit > newsig signalnameB bit > newsig signalnameC bit > linksp signalnameA <= inputpin1 > linksp signalnameA => axis.0.negativelimit > linksp signalnameB <= inputpin2 > linksp signalnameB => axis.0.positivelimit > linksp signalnameC <= inputpin2 > linksp signalnameC => axis.0.home > or
net signalnameA inputpin1 axis.0.negativelimit net signalnameB inputpin2 axis.0.positivelimit net signalnameC inputpin2 axis.0.home but http://www.linuxcnc.org/docview/html//man/man9/motion.9.html shows that the axis.N. names may need to be different, such as: net signalnameA inputpin1 axis.0.neg-lim-sw-in net signalnameB inputpin2 axis.0.pos-lim-sw-in net signalnameC inputpin2 axis.N.home-sw-in or functionally the same: net signalnameA inputpin1 axis.0.neg-lim-sw-in net signalnameB inputpin2 axis.0.pos-lim-sw-in axis.N.home-sw-in (inputpin1 and inputpin2, in real life, would most likely be different, such as: net signalnameA parport.0.pin-10-in axis.0.neg-lim-sw-in net signalnameB parport.0.pin-11-in axis.0.pos-lim-sw-in axis.N.home-sw-in when using a parallel port for the hardware interface) (I haven't verified any of the above with EMC2 software.) -- Kirk Wallace http://www.wallacecompany.com/machine_shop/ http://www.wallacecompany.com/E45/index.html California, USA ------------------------------------------------------------------------------ This SF.net email is sponsored by Sprint What will you do first with EVO, the first 4G phone? Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
