All good points.  I was trying to retain signal names for Hal configuration 
"watch" set up.
I'll do some translating this weekend.
Thanks guys!

-----Original Message-----
From: Andy Pugh [mailto:[email protected]]
Sent: Friday, July 23, 2010 7:59 AM
To: Enhanced Machine Controller (EMC)
Subject: Re: [Emc-users] Assigning 2 signal names to 1 pin

On 23 July 2010 13:27, James Louis <[email protected]> wrote:
>
> Thanks for the reply Kirk.  Having explained it, would you (or anyone) mind 
> translating the following generic sample to "net" without deleting any signal 
> names? :

I am curious about why you wish to retain both signal names? The
signal will only ever take one value, after all.
(I am actually not entirely sure why we have signal names at all,
other than making Halscope a little easier to setup)

Choose a signal name that suits all the uses of the signal, and just
have one name.

--
atp

------------------------------------------------------------------------------
This SF.net email is sponsored by Sprint
What will you do first with EVO, the first 4G phone?
Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users

This communication is for the use of the intended recipient only. It may 
contain information that is privileged and confidential. If you are not the 
intended recipient of this communication, the disclosure, copying, distribution 
or use hereof is prohibited. If you have received this communication in error, 
please advise me by return e-mail or by telephone and then delete it 
immediately.

------------------------------------------------------------------------------
This SF.net email is sponsored by Sprint
What will you do first with EVO, the first 4G phone?
Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to