Andy Pugh wrote: > 2009/12/2 Florian Rist <[email protected]>: > > >>> If the drives are linked by a belt, then it might simply be a case of >>> releasing some shaft clamps and running the axis up and down my hand, >>> re-tightening and re-checking. >>> >> I tried that, unfortunately I can only move one side by about 1 mm (about >> 3 mm would be required). >> Right, the linear rails were aligned with this offset of the screws. So, you need to loosen where the sliders attach, align the leadscrews, then tighten the linear slides.
I am assuming this machine is a bolted-together gantry router design. If this is a cast iron dovetail slideway machine, then something slipped when the ways were machined, and you are right, it is very hard to fix. ------------------------------------------------------------------------------ Join us December 9, 2009 for the Red Hat Virtual Experience, a free event focused on virtualization and cloud computing. Attend in-depth sessions from your desk. Your couch. Anywhere. http://p.sf.net/sfu/redhat-sfdev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
