I'd shift it in the CD software and run the CAM again.... On Tue, Dec 1, 2009 at 9:50 AM, Florian Rist <[email protected]> wrote: > Hi, > For the first time I have to mill a precise aluminum part and discovered > that the x and y axes of our CNC mill are not properly aligned at an > angel of 90° but show a deviation of about 10". > > Is it possible to correct this misalignment in software using EMC or > Mach3 (both soft CNCs are used here)? > > Thanks > Florian > > > ------------------------------------------------------------------------------ > Join us December 9, 2009 for the Red Hat Virtual Experience, > a free event focused on virtualization and cloud computing. > Attend in-depth sessions from your desk. Your couch. Anywhere. > http://p.sf.net/sfu/redhat-sfdev2dev > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users >
-- _________________________________ Rainer M. Schmidt Complex Consulting LLC [email protected] Voice (646)-657-8815 FAX (646)-435-9216 ------------------------------------------------------------------------------ Join us December 9, 2009 for the Red Hat Virtual Experience, a free event focused on virtualization and cloud computing. Attend in-depth sessions from your desk. Your couch. Anywhere. http://p.sf.net/sfu/redhat-sfdev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
