In Axis display the tool cone is moving at the opposite direction of my actual Z axis. The Z Axis is moving the correct direction. The tool cone is not following the measurements of the Z Axis. When the Z axis is raised, the tool cone shows it being on the work piece and when lowered it goes way below the work piece. Is there an file I need to edit?
The original set up was done with the stepper conf wizard. When done it also sets the min and max travel in my Z axis to 0.01 inch. I have just been going into the .ini file to change that. The travel of the Z axis I measured at 3.250 inches. Gary Fiber ------------------------------------------------------------------------------ Crystal Reports - New Free Runtime and 30 Day Trial Check out the new simplified licensing option that enables unlimited royalty-free distribution of the report engine for externally facing server and web deployment. http://p.sf.net/sfu/businessobjects _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
