> Am looking locally for a used computer to run Emc2 and my bench mill on, > out in my shop. I am thinking something less than $100 over 1G Hertz > with above 500 MB of memory. A dvd reader and CD writer. I have a 15 > inch screen and am thinking to connect with my inhouse computer with a > wireless hook up. This for maybe a cadcam program hook up. > Does this seem like a reasonable solution for the job? Are their > any suggestions that I ought to be thinking about when looking for one?? > Doug > > ------------------------------------------------------------------------------ > This SF.net email is sponsored by: > High Quality Requirements in a Collaborative Environment. > Download a free trial of Rational Requirements Composer Now! > http://p.sf.net/sfu/www-ibm-com > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users
The same intent recently drove me to Ebay where an IBM M50 2.8, 712 ram, CD read but not write. was purchased for $39 including shipping. the draw back is the small form factor. Oh, and Latency is no better than the 700 mhz box it replaced. But I'm in no hurry ;-) I can now run axis where the lesser machine would not. So, yes ebay is a source. Cheap bits! > ------------------------------------------------------------------------------ This SF.net email is sponsored by: High Quality Requirements in a Collaborative Environment. Download a free trial of Rational Requirements Composer Now! http://p.sf.net/sfu/www-ibm-com _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
