On Thu, 9 Apr 2009 17:20:38 -0400, you wrote: >Is there a fundamental difference between the Mach3 and the EMC G/M >Codes or will all regular/CAM generated stuff for Mach3 run also with
Turn differs, EMC uses G33 for threading, rather than the much more common G32, Toolchange parameters differ, as does CSS (Mach has an additional max speed parameter) As Steve said, some canned cycles differ, or aren't in EMC. For instance, G76 is totally different and some of the same parameters have radically different meanings and potentially damaging consequences. Other canned cycles may also have different parameters and behaviour, so you need to check those carefully in both Mill and Turn. Steve Blackmore -- ------------------------------------------------------------------------------ This SF.net email is sponsored by: High Quality Requirements in a Collaborative Environment. Download a free trial of Rational Requirements Composer Now! http://p.sf.net/sfu/www-ibm-com _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
