I can't completely understand the thc design and i have a few questions. 1. What is step size (in config file:THCStepSize)? What is used for? 2. Why dirhold, dirsetup, steplen and stepspace of Z axis have to be twice bigger then on other axises? Does it limit speed of other axises, or might other axises slow down? 3. How can I "slow down" reaction of Z axis? It has to big acceleration and because of that, the torch oscilate up and down few seconds after start? 4. If I turn on "corner high lock" and set big pierce gap, will it allow Z axis to move down during pearce delay (it's recommended not to allow)
Thank you, Sasa Vilic ------------------------------------------------------------------------------ This SF.net email is sponsored by: High Quality Requirements in a Collaborative Environment. Download a free trial of Rational Requirements Composer Now! http://p.sf.net/sfu/www-ibm-com _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
