On Wed, 28 Jan 2009, Richard Acosta wrote:
Date: Wed, 28 Jan 2009 00:28:26 -0200
From: Richard Acosta <[email protected]>
Reply-To: "Enhanced Machine Controller (EMC)"
<[email protected]>
To: "Enhanced Machine Controller (EMC)" <[email protected]>
Subject: Re: [Emc-users] 7i43 and pinout.
Let's see if i understood...
I must watch that .pin file to know where to connect encoders and pwmgen
¿am i right?
Yes
(I know this is beyond my knowledge) If i disable a specific function on
a pin and the pin becomes GPIO... ¿is this in any way usable?...¿or is
just a "flag"?
Forgive my shorthand, GPIO stands for General Purpose Input Output
Which means it can be used for Input (limit switches etc) or
Output (Spindle ON/OFF, Coolant ON/OFF etc)
Thanks again, and again, and again.
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
------------------------------------------------------------------------------
This SF.net email is sponsored by:
SourcForge Community
SourceForge wants to tell your story.
http://p.sf.net/sfu/sf-spreadtheword
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
