Aram, The 'tool table' is a file in the config directory with the default name of tool.tbl. There is a line in the .ini file to tell EMC what the name of the tool table is. You can name it anything you want. edit the tool.tbl file and then use the pull down menu to 'load tool table' your edits with then be usable G43 and G44 use the same file in opposite directions.
On Thu, Jan 1, 2009 at 9:04 PM, <[email protected]> wrote: > hi > i found 1 way about G43. > Page 80. > Exp. G44 H3 - offset for Tool 3 > than - "where the H number is the desired > index in the tool table. " > where is that "tool table"? > > >> hello >> i went to the wiki, and got the users manual >> then i looked in the index >> i found 2 ways to use tool length offsets inemc2 >> regards >> tomp >> >> [email protected] wrote: >>> Hi >>> I just finish run program with 86 000 lines. It took 4.5 hours. I finish >>> reinforcing frame of my machine and run program generated with VCARVE >>> product of Vectric . >>> >>> I also look for G43 H1 operation and cant can't find how to input H(n) >>> for >>> tool length like >>> H1… H2….Hn >>> How to input tool length offset H1 …. >>> Thanks >>> Aram >>> >>> >>> >>> ------------------------------------------------------------------------------ >>> _______________________________________________ >>> Emc-users mailing list >>> [email protected] >>> https://lists.sourceforge.net/lists/listinfo/emc-users >>> >> >> >> ------------------------------------------------------------------------------ >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
