Mark, Thanks for the quick reply. i have enquired about the driver cards.
Frank > Thier units appear similar to my homemade gantry router except thiers > looks > much better. > > They show that it is driven by the parrallel port, but have no > documentation > on what card they are using. They are showing Mach2 as the driving > software > so setting up for EMC2 should be straightforward. > > You might request additional information on the motion cards and the > steppers just to be sure, but it appears to me to be a good candidate. > Just > my opinion. > > On Mon, Dec 29, 2008 at 11:31 AM, <[email protected]> wrote: > >> I am considering an Digirout cnc router. Does anyone have any >> experience >> with their products and EMC2? Any info would be appreciated. >> >> Thanks, >> >> Frank >> >> >> >> ------------------------------------------------------------------------------ >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
