El 21/12/2008 05:42 p.m., John Kasunich escribió:
> Stuart Stevenson wrote:
>
>> On Sun, Dec 21, 2008 at 1:01 PM, Richard Acosta <[email protected]> wrote:
>>
>>> Is nothing about lazyness... is about being tired of to do something
>>> that is supossed to work.. and it does not! again and again and again.
>>>
>>> When going your lazy path i got the following two messages.
>>>
>>> "Acercar linea 10 en /usr/shareaxis/images/axis.ngc: bad character "x" used"
>>>
>> this message tells you there is something wrong near line 10 of the file:
>> /usr/shareaxis/images/axis.ngc
>>
>> it even tells you what is wrong:
>> bad character "x" used
>>
>> your response to this should be:
>> open the file with an editor and look for an "x" character on or near line 10
>> if you cannot figure out what the error is then post a copy of a few
>> lines prior and a few lines past
>>
>> someone will try to help you
>> people are trying to help you now - they just don't have enough information
>>
>
> Something is fishy here though - isn't axis.ngc the EMC2 splash screen
> program? Hundreds of users are loading that g-code file every time they
> start EMC, and it isn't causing errors.
>
> Also, "X" is a perfectly legitimate character in g-code.
>
> Stuart is exactly correct in that the proper action is to READ the
> message, THINK about what it means, and LOOK for the cause of the problem.
>
> Regards,
>
> John Kasunich
>
I didn't wrote that file!!!
it comes with the last install of EMC2 wich was suppossed to be working
on a lazy path and a couple of clicks as i did this time.
------------------------------------------------------------------------------
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
