Well... Try here also... http://drillcity.stores.yahoo.net/monspec1.html
----- Original Message ----- From: "Andrew Ayre" <[EMAIL PROTECTED]> To: "Enhanced Machine Controller (EMC)" <[email protected]> Sent: Monday, June 16, 2008 12:28 PM Subject: Re: [Emc-users] Endmills > Thanks Dean! I placed an order with them. I like the fact that they are > family owned and operated. Wish they had 10pc combo packs for end mills > though. > > Andy > > Dean Hedin wrote: >> Andrew, >> Since you are using a dremel then you will need to go with the tiny >> milling >> bits. >> Something like these: >> http://drillbitcity.com/catalogue/special_tools.asp >> >> You usually go with ball nose when you are profiling a surface in 3d. > > > -- > Andy > PGP Key ID: 0xDC1B5864 > > ------------------------------------------------------------------------- > Check out the new SourceForge.net Marketplace. > It's the best place to buy or sell services for > just about anything Open Source. > http://sourceforge.net/services/buy/index.php > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
