Hi, When running emc2 to control the lathe, I noticed a strange (or maybe intentional :-) ) move concerning backlash:
Supposing I'm at X10 and doing a move G0 X0, the system executes this move and immediately follows it by a small countermove to take up the backlash. I have the impression, that when running on the mill, the backlash move is only done before the move, not after. Is there any way to influence this behaviour, eg make it happening before a move instead of after? Thanks, Geert ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
