OK, more dumb questions. Would a short ball screw do what you want? It certainly would be more precise than acme rod; or do I miss the intent?
If I remember I can bring ER40 1", .75 and .625 collets. I think I have all three. Dave On Jun 6, 2008, at 3:23 PM, John Kasunich wrote: > Chris Radek wrote: >> On Fri, Jun 06, 2008 at 03:13:01PM -0700, Dave Engvall wrote: >>> I just checked the wiki and someone wanted some acme thread for >>> fest. >>> I happen to have some 1" if they can figure out a way to mount it. >>> Any idea who we blame for this? >>> >> >> That's my request! If you have a shortish piece, and if the collet >> chuck I remember being there is ER40, and if I bring a 1" ER40 >> collet, >> it would be perfect. >> >> That's a lot of ifs, isn't it? >> >> Chris >> >> >> > > I'll be bringing a piece of 5/8-5 acme as well, so we'll have two > shots > at mounting a threaded test piece to the spindle. > > Regards, > > John Kasunich > > ---------------------------------------------------------------------- > --- > Check out the new SourceForge.net Marketplace. > It's the best place to buy or sell services for > just about anything Open Source. > http://sourceforge.net/services/buy/index.php > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
