Hi
I'm building a little cnc router with EMC2 as the
controller software running with Xylotek steppers and
everything works fine but when i try to reboot or
shutdown ubuntu it stops with a "segmentation fault"
error. This only happens when i run EMC2, if i run any
other program from ubuntu except EMC2 then it behaves
normally.
The installation was done using the default cd with
EMC2.2 and it does the same thing with another
computer
i have. is this a problem with EMC2 and my hardware?
PC#1 CPU PIV 2.8Ghz. 640MB RAM
Graphics card Nvidia Geforce4 MX 440
PC#2 CPu PIV 2.26Ghz 512MB RAM
Graphics card Ati Radeon 9200
Just another question: is there a way to disable auto
mode until you homed
all X,Y and Z axis ? Thank you.
Ulises.
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
