Gentlemen,
I have the Motenc-lite board with the Enc-Dac board and two I/O boards. So
as I understand it, I should have 32 digital inputs and 16 outputs. But when
I try to change the "number of physical inputs" parameter to anything above
16 or the outputs above 8, I get an error and EMC no longer loads. Have I
done something wrong? Do I have to define them first? If I change it back to
16/8 everything loads fine.
Thanks
Glenn Stewart
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
