> I was kinda hoping no one would ask that. Hi, I'm the one in every crowd...:)
I just hooked up the AXIS > Flood button to the bit input of my component. Which would give the > component all ones or all zeros, except when the input is changed during > a conversion cycle. This shouldn't make too much difference, a bit is a > bit is a bit. So when Flood is on, I get an output of 4095, and 0 when > off. Is there any way to set up a pot or even just some resistors as a voltage divider in the office to test the ADC input? Something that should read as a mid-range value. It might not convert as exactly half of full scale, but it might point toward an answer. Javid ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
