[EMAIL PROTECTED] wrote: > > It looks like HAL mist and flood sigs are connected to a couple of the > outputs on the AX IO board but it doesn't look like they connect back to > iocontrol or halui. This should not be a difficult task. The HAL > connections are trivial, even if we add a coolant override switch to the > front panel and show off with a ladder rung. > > We'd just have to chase down the coolant motor relay puller and connect it to > to ax5214h.0.out-16 and make certain we have the correct output module at > that location. Then I'd think we'd want to connect the motor overload back > into inhibit or at least to an operator message. > > Rayh >
And most important of all, we want to replace the ancient and smelly brew in the sump with fresh coolant _before_ we start the pump! Regards, John Kasunich ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
