Dear All,
A non-technical question for everyone. Does anyone using
EMC2 trust it enough to
machine expensive parts on a regular basis? This question was prompted
by a friend of mine
who is a big fan of Mach 2/3 Windows (sorry for the bad language !!)
based controller. He said
that he didn't know if he would trust Mach 2/3 enough to machine
anything of value !!!! BTW, I have
been following the development of EMC from BDI 2.x to the present and I
think in it's present state it
looks virtually as good as some commercial CNC controls. So, a very big
thank-you to everyone
clever enough to write this sutff (not me unfortunately).
Thanks,
David
Winter.
P.S. Do you have to be invited to the CNC workshop or do you apply
somehow?
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
