Yes, please go ahead. > Gesendet: Sonntag, 12. April 2026 um 12:30 > Von: "Hans Unzner" <[email protected]> > An: [email protected] > Betreff: Re: [Emc-developers] Weblate LinuxCNC/Gmoccapy locked - why? > > Ok, but the conflicts in the component linuxcnc-docs does not affect > gmoccapy. Also the linuxcnc component is not locked, so I think it's > fine to unlock gmoccapy. Agree? > > Hans > > Am 12.04.26 um 11:58 schrieb Steffen Möller via Emc-developers: > > Hello, > > > > There is some nasty conflict with the Weblate documentation > infrastructure for a couple of weeks already that I did not get around to > address. Have not addressed anything particular for LinuxCNC/Gmmoccapy. > > > > Best, > > Steffen > > > >> Gesendet: Sonntag, 12. April 2026 um 11:08 > >> Von: "Hans Unzner" <[email protected]> > >> An: [email protected] > >> Betreff: [Emc-developers] Weblate LinuxCNC/Gmoccapy locked - why? > >> > >> Hi, > >> > >> Did somebody lock the Weblate Gmoccapy component? It seems not that > >> there are problems so I would like to unlock that. Any reasons not > to do so? > >> > >> Hans > >> > >> > >> _______________________________________________ > >> Emc-developers mailing list > >> [email protected] > >> https://lists.sourceforge.net/lists/listinfo/emc-developers > > > > _______________________________________________ > > Emc-developers mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-developers > > > > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers</[email protected]>
_______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
