On Wed, Oct 09, 2013 at 02:28:30AM +0000, James Harkins wrote:
> Suvayu Ali <fatkasuvayu+linux <at> gmail.com> writes:
>
> > On Tue, Oct 08, 2013 at 11:41:36PM +0800, James Harkins wrote:
> > > Question: How does one use Beamer's \only command with blocks?
> (Successfully, with org-mode's beamer
> > export, I mean.)
> > >
> > > I found in the manual that you can give an overlay specification using
> > > the BEAMER_ACT property... ok... but that's not the same as \only
> > > because, when a latex chunk is marked \only<1>, it takes *no space* on
> > > <2->. Using <1> and <2> causes the <2> to appear lower than the
> > > <1>. That's not what I want.
> > >
> >
> > Did you try this:
> >
> > <http://orgmode.org/worg/exporters/beamer/ox-beamer.html#environments-overlay>
>
> My example file uses BEAMER_ACT, so yes, I did try that. Here's what happens
> if I try it with \only<1>.
Look a bit more carefully ;). The following paragraph has an example
suggesting the onlyenv environment. As far as I understand,
environments are prefered over commands with arguments or macros when
translating headlines. You can nest your block in such an environment.
I realise this is a little less flexible than \only{}, but it seems to
work. I have not tried any of this personally in a long time though.
Hope this helps,
--
Suvayu
Open source is the future. It sets us free.
