On Tue, Mar 26, 2013 at 3:16 PM, Ken Williams <ken.willi...@windlogics.com> wrote: > I’m using a ‘dot’ section to create an SVG image, then exporting my document > to HTML:
[deleted] > My diagram ends up pretty huge though, and I want to shrink it down. > ":width 1000" doesn’t seem to have any effect, nor does wrapping like so: [deleted] > Any suggestions? This works for me on version 8.0-pre #+attr_html: :width 100% [[image.svg]] Are you using the new exporter or old? I believe the old syntax would have been: #+attr_html width="100%" [[image.svg]] But try with and without quotes (I can't check for the old exporter syntax on my setup anymore... well, I /could/ but that's a lot of work!). John > > I’m using version 7.9.2-dist . Thanks. > > > > -- > > Ken Williams, Senior Research Scientist > > WindLogics > > http://windlogics.com > > > > > ________________________________ > > CONFIDENTIALITY NOTICE: This e-mail message is for the sole use of the > intended recipient(s) and may contain confidential and privileged > information. Any unauthorized review, use, disclosure or distribution of any > kind is strictly prohibited. If you are not the intended recipient, please > contact the sender via reply e-mail and destroy all copies of the original > message. Thank you.
