Hello, I've recently started to use my K2/KPA100 on SSB running 100W with an MH2 mike mostly on 80m. I use 2:1 compression and mic preamp is set to 2. The antenna is an 120ft doublet, 30ft of 300ohm ribbon feeder, remote mounted z match tuner right under the centre of the doublet and approx 70ft RG58 coax to the rig. I have no RF earth but neither do I get much RFI in the house. One end of the antenna is about 10m above the operating position and I'm on the ground floor. I've had varying reports on the audio quality. Here are a few things I have done/found: Every now and then I would get a high current message after which my RF peaks (as shown on the K2 bargraph) would drop right down. My remote mounted z match tuner uses old broadcast receiver variable caps and I think one of them might have been flashing on speech peaks. I have backed off the power to 90W and it seems a lot better. The funny thing is that when I run at 100W on CW I don't have any probs (ie no high current messages). Is there something about the RF peaks on SSB, do they overshoot sometimes or is it something to do with rate of rise of the RF voltage? When I first start an over on SSB the bargraph follows the speech waveform and is what I could call "lively" but sometimes it goes very sluggish and doesn't seem to be following the audio, is this normal. Sometimes the bargraph seems to disappear altogether. The antenna and tuner are balanced and I've added a choke balun and various ferrites (inc 3 turns on the mic lead and 4 turns on the power supply lead) to keep any RF off the rig chassis. I hold the mic about 4 inches away since I thought I might be overdriving the audio. I did have reports of sounding like I was speaking through a kazoo but I think I may have fixed that by moving the power supply (linear one with big toroidal tx) a bit further away from the rig. Some guys report that it sounds a bit scratchy. I have checked the KPA100 biasing and it is spot on with the manual and also the carrier suppression. Unfortunately I don't have another rig to monitor my signal. I do have a 30Meg scope. I don't think the audio is bad but perhaps not the best I could get out of the K2. Are there any tests/mods/tricks I could try??
Costain Group PLC, Registration Nos.: 1393773 Costain Ltd, Registration Nos.: 00610201 Costain Building & Civil Engineering Ltd, Registration Nos.: 01054232 Costain Engineering & Construction Ltd, Registration Nos.: 02440829 Costain Engineering & Construction (Overseas) Ltd, Registration Nos.: 02440830 Costain Oil, Gas & Process Ltd, Registration Nos.: 00786418 Registered Office: Costain House, Vanwall Business Park, Maidenhead, Berkshire, SL6 4UB. The information contained in this e-mail is confidential and may be privileged. If you are not the intended recipient you must not copy, distribute or otherwise disclose its contents. If you have received this e-mail in error please notify us immediately and then delete the message. Please visit www.costain.com Before you print think about the ENVIRONMENT This message has been checked for all email viruses by the NetscanCentral solution. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
