Ah yes. Thank you Don. Clearly I've been working too far past my bed time.
73, Joe On Jun 11, 2010, at 12:21 AM, Don Wilhelm wrote: > Joe, > > Cutting the tip off the stem bumper is not drastic at all, and is exactly > what is called for in the instructions. See the first step on page 60 of the > K2 manual in the right column. > > With the stem bumper cut, you can then press down on the resistor body to > tighten the fastenings for L33. Note that the high value resistor is really > treated as an insulator - its only purpose is to secure L33 and provide > convenient points for soldering the wires of L33. > > 73, > Don W3FPR > > KC8YFH wrote: >> Hi all, >> >> Slowly but surely K2 #6773 is coming together. I've noticed that the stem >> bumper included for the L33 toroid actually protrudes through the middle a >> small distance. This will elevate R116 above the toroid, which is not what >> the instructions (page 61, first column, first instruction) suggest. I'm a >> bit worried about R116 atop the stem bumper being taller than the standoffs >> to the bottom of the case and thus getting mashed when the case is assembled. >> >> I could cut the center of the stem bumper to shorten it, but that seems >> drastic... Any ideas? >> >> Thanks >> Joe KC8YFH >> >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
