I found that my K1 was very sensitive to having good electrical contact. I had trouble with paddles that didn't have the bearings bypassed. The same paddles worked fine with my K2. I think this issue would be more likely with ball bearing paddles. I was using Kent twin lever paddles. They were not bypassed like their single lever model was. It used a small piece of braid to go from ground to the bearing spindle.
73, Rick Dettinger K7MW On Jun 1, 2010, at 3:08 PM, [email protected] wrote: > Ok, radio is up but I am having an issue with my paddle. The dit side > of the paddle will occasionally send dah dit instead of just a > dit...suggestions? > > Greg Doughty > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
