Hi Guy: Additional information.
Firmware MCU 3.79, DSP 2.54 No antenna involved. Dummy load only. VOX on (not QSK) CWT on TEXT DEC off Internal keyer used, set to 23 WPM but other speeds do it too External paddle (non-iambic). CONFIG:CW IAMB.......A CONFIG:CW PADL......tip=dot CONFIG:CW WGHT....1.05 73, Mike K2MK Guy, K2AV wrote: > > Firmware & DSP versions? > > On Tue, Apr 13, 2010 at 10:40 AM, Mike K2MK <[email protected]> wrote: >> >> My fist has been getting rusty so I've begun practicing sending CW by >> putting >> the K3 into TEST mode and sending paragraphs of text. I discovered that >> when >> going back to normal TX mode, the power output was drastically reduced. >> At >> first I thought I was accidentally turning the power knob to adjust >> keying >> speed so today I conducted a controlled experiment. >> >> I set the K3 keying speed to 23 WPM and did not readjust it. I found that >> it >> is necessary to send CW in TEST mode for about 5 minutes for the >> condition >> to occur. I tried it on 3 bands at 3 different power levels. In each case >> I >> noted the power before going into TEST mode and then after 5 minutes I >> noted >> the power after exiting TEST mode. The power was read on my PowerMaster >> meter into a dummy load but a touch of the K3 POWER knob confirmed that >> the >> K3 and the PowerMaster agreed with each other. >> >> Here's what I found. >> >> 17 meters: power reduced from 29 watts to 5.2 watts >> 20 meters: power reduced from 24 watts to 5.1 watts >> 30 meters: power reduced from 100 watts to 5.0 watts >> >> Give it a try. >> >> 73, >> Mike K2MK >> -- >> View this message in context: >> http://n2.nabble.com/K3-power-reduction-after-using-TEST-mode-tp4896438p4896438.html >> Sent from the Elecraft mailing list archive at Nabble.com. >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > -- View this message in context: http://n2.nabble.com/K3-power-reduction-after-using-TEST-mode-tp4896438p4896767.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
